Q: Do I have to do anything to my printer?
A: No, the Create-A-Flag™ can be printed on any Inkjet printer, just like paper.
Q: Do I have to use special ink?
A: No, our specially designed Printable Flags™ are engineered to accept all standard Inkjet ink.
Q: My flag curled slightly when I pulled the paper-backing off. How can I fix it?
A: No problem! Once attached to dowel, roll the flag in the cup of your hand in the opposite direction.
Q: Can I set my margins so my flag prints closer to the edge like a real custom flag?
A: Yes! You can set your margins as small as possible, just make sure to leave your 1″ left margin and print a test page to make sure everything fits. You can also TRIM DOWN YOUR FLAG AFTER PRINTING AND BEFORE REMOVING PAPER-BACKING TO GET THE LOOK OF A REAL CUSTOM FLAG!
Q: A tiny bit of ink was on the edge of my flag after printing. What do I do?
A: Before peeling off the backing paper, trim off with sharp scissors before attaching to sleeve.
Q: Is this the only size?
A: Watch for the Create-A-Flag Flag Making Centers for additional flag sizes coming soon!
Q: How are the flags interchangeable?
A: The dowels are reusable, so you can change out your flags whenever you want with replacement flags.
Q: Does the flag slip on and off the dowel?
A: Yes, the dowel and sleeve are designed to allow for fast, simple and secure assembly.
Q: Do I have to do anything to my flag if I am going to use it outside?
A: It is reccomended that you rinse your flag before outdoor use, since each printer’s ink is different. Rinsing your flag for 15-seconds will set it for OUTDOOR USE, regarless of the ink used.
Hint: Flag pole fits into standard 1″ binder clips, so you can clip your flag anywhere
Balloons Deflate and Flowers Die, but the Create-A-Flag will Always Fly!™